1989 GTA armrest bezel trim
#2
Community Administrator
iTrader: (1)
Re: 1989 GTA armrest bezel trim
@hawksthirdgen used to offer this as a reproduction but it's no longer listed on their website. I was going to buy a set.
They commonly crack and/or warp.
They commonly crack and/or warp.
#4
Junior Member
Thread Starter
Re: 1989 GTA armrest bezel trim
I was thinking the same about 3D printing. Should be an easy process, not too much detail to the part and small enough too. Can be painted to match.
The following users liked this post:
89 GTA 355 (01-02-2024)
#6
Supreme Member
iTrader: (101)
Join Date: Feb 2004
Location: Levittown Pa
Posts: 1,914
Likes: 0
Received 19 Likes
on
17 Posts
Car: 89 Iroc Convertible
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.27 Posi 9 bolt PBR
Re: 1989 GTA armrest bezel trim
Years ago There was a guy named Dave on Facebook who was 3d printing these armrest trims
The following users liked this post:
89 GTA 355 (01-02-2024)
Trending Topics
#8
Senior Member
iTrader: (4)
Join Date: Feb 2004
Location: San Diego, CA
Posts: 735
Likes: 0
Received 7 Likes
on
3 Posts
Car: 89 GTA
Engine: 6.0L Procharged
Transmission: T-56
Axle/Gears: 4.10
Re: 1989 GTA armrest bezel trim
I'm the guy who was making these. I just don't have the time to sand/prime/paint them anymore so I stopped selling to Hawks. I can provide blanks for anyone who wants to do the finishing work and paint them. Takes about 5 minutes of hand sanding them with 150-200 grit, then a final sand with 400 grit, prime, and paint.
I'm selling the blanks for $25/pair shipped if anyone wants them you can DM me.
I'm selling the blanks for $25/pair shipped if anyone wants them you can DM me.
The following 4 users liked this post by 89mulletbird:
#9
Member
Join Date: Dec 2021
Location: central Texas
Posts: 281
Received 106 Likes
on
75 Posts
Car: 91 TA Vert WS6-94 TA Vert
Engine: 5.0/5.7 LT1
Transmission: 700R4
Axle/Gears: 2.73-3.42
Re: 1989 GTA armrest bezel trim
I was at my car today, (91 TA, I keep in a building I own about a mile down the road from the house,) but I honestly cannot remember if they're there or not.
if not, I'll be backbat you!
Thanks!
if not, I'll be backbat you!
Thanks!
#11
Senior Member
iTrader: (4)
Join Date: Feb 2004
Location: San Diego, CA
Posts: 735
Likes: 0
Received 7 Likes
on
3 Posts
Car: 89 GTA
Engine: 6.0L Procharged
Transmission: T-56
Axle/Gears: 4.10
Re: 1989 GTA armrest bezel trim
I'm still catching up from the orders from the TTA guys, I'll post an official thread in a week or two once I am ready to make another run.
Thread
Thread Starter
Forum
Replies
Last Post
alan91z28
Auto Detailing and Appearance
4
06-04-2021 04:30 PM