Spohn problem
#1
Spohn problem
Ok so ive already found out im having the common problem of my engine and k member not being level with each other. Is there any way to fix this? And its not clearing my A/C compressor like hawks said it would any ideas?
#2
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,905
Likes: 0
Received 97 Likes
on
59 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: Spohn problem
Throw the spohn k-member in the scrap bin and fab a new pass mount that levels the engine out
#3
Supreme Member
iTrader: (2)
Re: Spohn problem
I had exactly the same problem with my Spohn k-member. You can get creative with the motor mounts to make up the difference and level the engine. I'm running solid mounts so that made it a little easier. My mounts look like the ones attached below. I had the tube cut out where the long bolt slids through then re welded .3in higher. Luckily I have a friend with the fabrication tools and skill who lives right around the corner. I moved mine about .3in if I remember correctly.
So depending on what mounts you are using you may want to modify the mount or k-member itself to level the engine. Spohn was of no help when I contacted them about the problem.
So depending on what mounts you are using you may want to modify the mount or k-member itself to level the engine. Spohn was of no help when I contacted them about the problem.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM