intercooling a draw through
01-23-2008, 08:30 PM
#1
Banned
Thread Starter
iTrader: (3)
Join Date: Dec 2007
Posts: 275
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2006 Ford Mustang
Engine: 4.0 V-6
Transmission: Automatic
Axle/Gears: not sure
intercooling a draw through
is it possible or would fuel just collect in it and blow up at some point?
01-23-2008, 09:49 PM
#3
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: intercooling a draw through
Yea, not possible.
Are you stuck using a drawthrough for some reason? If there's anyway to fight your way out of that, so you can use a blowthrough, i'd go that route.
Unless we're talking about a roots setup?
Are you stuck using a drawthrough for some reason? If there's anyway to fight your way out of that, so you can use a blowthrough, i'd go that route.
Unless we're talking about a roots setup?
01-23-2008, 11:39 PM
#4
Banned
Thread Starter
iTrader: (3)
Join Date: Dec 2007
Posts: 275
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2006 Ford Mustang
Engine: 4.0 V-6
Transmission: Automatic
Axle/Gears: not sure
Re: intercooling a draw through
Oh well was just a thought. Just trying to get a little more power out of this engine but so far seems like I am stuck in the 165hp land ... Moving on to plan B since plan A failed LOL
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
06-13-2021 01:13 PM
Street Lethal
Power Adders
634
04-30-2019 12:14 PM
gta892000
Cooling
6
09-16-2015 12:37 AM
