5.0 TBI question
#1
Junior Member
Thread Starter
Join Date: Feb 2013
Location: dayton, OH
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Camaro RS
Engine: 305 sbc
Transmission: 700r4
5.0 TBI question
So, i have a 5.0 tbi, bone stock. wanting to clean up the engine bay, make it look nice, decided to go with an open element air filter, but my problem is i have an MAF sensor attatched to the stock breather. any way i can take it off? what would happen if i did? or, is there anyway i can drill into the bottom of my open element air filter and attatch the MAF sensor to it, and if so, how? thanks
#2
Junior Member
iTrader: (1)
Join Date: May 2012
Location: Triad, NC
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 RS
Engine: Stock L03
Transmission: Stock T5
Axle/Gears: Stock, Too high
Re: 5.0 TBI question
That's the Intake Air Temp sensor, not MAF, your car uses MAP. What to do with the IAT is mentioned in the above sticky threads, you can either install it in the aftermarket cleaner base or tie it up somewhere in the engine bay, cooler generally better.
#3
Junior Member
Thread Starter
Join Date: Feb 2013
Location: dayton, OH
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Camaro RS
Engine: 305 sbc
Transmission: 700r4
Re: 5.0 TBI question
Really? huh, had no clue. thanks man.
#4
Junior Member
Thread Starter
Join Date: Feb 2013
Location: dayton, OH
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Camaro RS
Engine: 305 sbc
Transmission: 700r4
Re: 5.0 TBI question
What exactly is it connected to (other than the breather) and what affect on the car would there be if i removed it?
Thread
Thread Starter
Forum
Replies
Last Post
Iroc8t8
TPI
43
08-26-2015 08:14 AM