lt1 what can i use on my lo3
#1
Member
Thread Starter
Join Date: Jul 2012
Location: greensboro,nc
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 camaro
Engine: 305
Transmission: 700r4
Axle/Gears: 2.73
lt1 what can i use on my lo3
lt1 can I uses the head and intake on it? I know the cam but is there anything else?
#4
TGO Supporter
iTrader: (1)
Re: lt1 what can i use on my lo3
A search came up with this
http://forums.corvetteforum.com/c4-t...e-miniram.html
http://forums.corvetteforum.com/c4-t...-my-setup.html
https://www.thirdgen.org/forums/alte...nversions.html
http://forums.corvetteforum.com/c4-t...e-miniram.html
http://forums.corvetteforum.com/c4-t...-my-setup.html
https://www.thirdgen.org/forums/alte...nversions.html
Last edited by Ronny; 07-22-2013 at 04:30 PM.
#6
Member
iTrader: (2)
Join Date: Jul 1999
Location: Lynn Haven/Panama City, FL, USA
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Monte SS
Engine: Super-rammed L-98 383
Transmission: T-56 6-Speed
Axle/Gears: 8.5" G-BODY G-80 3.73
Re: lt1 what can i use on my lo3
You can all parts internal from the LT1, I.E., the entire valvetrain system, the rotating assembly, with the exception of the Pistons of course. The rotating assembly is stronger than your stock L03 setup. You will have to use your L03 harmonic balancer. You will also have to have the LT-1 crank and rods balanced with the 305 pistons, if you use them. You can also use the oilpan, and flexplate plate from the LT1, whether the flexplate is the (12-3/4"/153 tooth) version found on most F-BODY and Y-BODY LT1s, or a (14"/168 tooth) versions, found on the B-BODY LT1s. The flexplate choice is heavily dependent on whether your L03 block is machined for both STARTER sizes. If so, then the choice is yours . HTHs
Thread
Thread Starter
Forum
Replies
Last Post
88SS6SPEED
Engine/Drivetrain/Suspension Parts for Sale
7
11-11-2015 07:05 AM