Code 36 issue
#1
Junior Member
Thread Starter
Join Date: Jun 2014
Location: NorCal
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89' Iroc Z
Engine: LB9
Transmission: 5 speed manual - warner gear
Code 36 issue
So i got a code 36.
When i look it up on chilton/alldata it explains the issue is "ignition control 24x signal circuit error". Now when i cant wrap my head around is why the forums say its a "Burn off at mass air flow sensor OR Problem in transmission shift OR Fault in direct ignition system OR Missing pulses in electronic spark timing signal"
Anyways moral of the issue is, driving, engine warmed up, stalls/dies out.
Crank sensor or fitting is faulty or lose? Not entirely sure, maybe faulty ICM, ignition coil?
Any help, advice, knowledge is greatly appreciated.
When i look it up on chilton/alldata it explains the issue is "ignition control 24x signal circuit error". Now when i cant wrap my head around is why the forums say its a "Burn off at mass air flow sensor OR Problem in transmission shift OR Fault in direct ignition system OR Missing pulses in electronic spark timing signal"
Anyways moral of the issue is, driving, engine warmed up, stalls/dies out.
Crank sensor or fitting is faulty or lose? Not entirely sure, maybe faulty ICM, ignition coil?
Any help, advice, knowledge is greatly appreciated.
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,401
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: Code 36 issue
If this is the car in your mini-sig ('89 LB9), it is a MAF burn off relay malfunction.
Note that this is the TBI section, not the TPI section. An LB9 is a TPI set up.
RBob.
Note that this is the TBI section, not the TPI section. An LB9 is a TPI set up.
RBob.
#3
Junior Member
Thread Starter
Join Date: Jun 2014
Location: NorCal
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89' Iroc Z
Engine: LB9
Transmission: 5 speed manual - warner gear
Re: Code 36 issue
Oh wow I must be becoming illiterate. Or just really tired..could of sworn I posted in the TPI section. Thanks, much appreciated.
#4
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,401
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: Code 36 issue
Probably tired, I've done the same when responding to fuel pressure thread on the TPI board. Thought it was the TBI board and posted the wrong info. Did correct it the next day when I saw it...
RBob.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
777Shock777
Tech / General Engine
4
10-29-2015 04:30 PM
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM