Car Starts But Goes Dead Afterwards...
#1
Member
Thread Starter
Join Date: Sep 2003
Location: Atlanta Georgia
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Trans Am GTA
Engine: 350 5.7 L98
Transmission: 700R4
Car Starts But Goes Dead Afterwards...
I changed my valve cover gaskets on my '89 L-98 GTA
the other day.Everything I thought went smoothly they came off and went back on.
Now when I start the car it runs for about 30 seconds and goes dead.It ran fine till I changed the valve cover gaskets.Can someone tell me what have I done wrong and how can I fix the problem?
Any help you guys can give me will be appreciated and trust me i need help badly with this problem.Thanks in advance for any help and/or suggestions!
the other day.Everything I thought went smoothly they came off and went back on.
Now when I start the car it runs for about 30 seconds and goes dead.It ran fine till I changed the valve cover gaskets.Can someone tell me what have I done wrong and how can I fix the problem?
Any help you guys can give me will be appreciated and trust me i need help badly with this problem.Thanks in advance for any help and/or suggestions!
#2
Member
Join Date: Jun 2003
Location: Upstate NY
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Z28
Engine: 383 Stroker
Transmission: 700-R4
sounds like you have a vacume leak (a bad one) my friend. Make sure all your vacume lines are connected where they should be. I know b/c I have gone through this before and I know how frustrating it is. Do that and your problem should go away.
#3
Member
Thread Starter
Join Date: Sep 2003
Location: Atlanta Georgia
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Trans Am GTA
Engine: 350 5.7 L98
Transmission: 700R4
I will check for vaccum leaks.But I was extra careful not to take
anything apart or loose that did not need to be disconnected.
Thanks for the pointer...
anything apart or loose that did not need to be disconnected.
Thanks for the pointer...
#6
Supreme Member
Join Date: Nov 2003
Location: Philly
Posts: 1,965
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 firebird
Engine: Pos 2.8 pulled and replaced with a 350 tpi motor converted to carb.
Transmission: 700r4, vette servo,shift kit, hayden 15"x8" trans cooler.
my car is doing that also after a head gasket install, turns out the rubber boot that the pcv hose goes in had a huge 1/4 inch crack all the way down it.
Its those damn gremlin you know!
Its those damn gremlin you know!
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM