300+ ?
#1
300+ ?
I have an 88 L98 with a Throttle Body Injection System on it. I plan on modifying the car significantly, and am aiming for over 300 horsepower. So far, I plan to install:
Dual Snorkel Intake
Ultimate TBI
LT1 Roller Cam
engine-back 3 in exhaust
Edelbrock Performer 3704 Intake Manifold
How far do you think this combo will take me? I know i should get a chip burned, how exactly should i go about that?
Any advice is much appreciated. Thanks guys.
Dual Snorkel Intake
Ultimate TBI
LT1 Roller Cam
engine-back 3 in exhaust
Edelbrock Performer 3704 Intake Manifold
How far do you think this combo will take me? I know i should get a chip burned, how exactly should i go about that?
Any advice is much appreciated. Thanks guys.
#4
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
headers.
Go bigger than the LT1 cam, it's just so small...
Go bigger than the LT1 cam, it's just so small...
#5
Supreme Member
iTrader: (2)
Join Date: Feb 2003
Location: Chicago
Posts: 1,583
Likes: 0
Received 1 Like
on
1 Post
Car: Only a daily driver, but comin home
Engine: I have one that runs ;)
Transmission: Caged hamster that runs really fast
Axle/Gears: They are round, I know that much
That TBI is choking the heck out of that 350......I would completely change the whole intake setup, either go full TPI or another FI system, or slap on a carb and tune away from there.
#6
i thought that if i slapped on a 2" bore TBI it would flow correctly, right around 650-670 cfm.....and i had planned on headers as well, sorry for not specifying. would you recommend an LT4 cam instead?
thanks guys
thanks guys
Thread
Thread Starter
Forum
Replies
Last Post
Yarnboy
Auto Detailing and Appearance
22
03-22-2001 08:36 AM