Question about my lower end build.
10-18-2007, 09:58 PM
#1
Member
Thread Starter
Join Date: Jun 2005
Location: Tucson, AZ
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 GTA
Engine: L98 350
Transmission: Swapped to a T-5
Axle/Gears: 3.27
Question about my lower end build.
This might be a stupid question but I want to make sure things are okay. Before I put my heads on, when I would turn the crank with all the pistons in sometimes it would get hard to turn. But with the crank bolt on it never went over 30 ftlb. I measured this by using my torque wrench on the crank bolt. I think its okay but it has me worried a little so I just want to make sure, thanks for the help.
10-18-2007, 10:52 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,123
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Question about my lower end build.
30 ft-lbs is about right. I'd say anything in the 20-35 range would be pretty normal. So there's nothing wrong with what you're seeing.
Thread
Thread Starter
Forum
Replies
Last Post