cam question????
02-16-2009, 05:49 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2009
Location: Sanford Maine
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 firebird formula
Engine: 5.0 tpi
Transmission: t-5
cam question????
can I run a retro fit roller cam in my 90 factory roller block?and what would happen if i ran a non-computer controlled cam in my car?
02-16-2009, 07:05 PM
#2
TGO Supporter
Join Date: Jul 2003
Location: Grand Rapids, MI
Posts: 4,803
Likes: 0
Received 0 Likes
on
0 Posts
Car: Z28
Engine: Sb2.2 406
Transmission: Jerico 4 speed
Axle/Gears: Ford 9" 3.60
Re: cam question????
It will fit. You will need an early model cam plate, thrust button, and early model timing set. Most people use a factory roller cam in factory roller blocks
Depending on size, many non-cc cams running in computer controlled cars end up running like junk until they're properly tuned.
Depending on size, many non-cc cams running in computer controlled cars end up running like junk until they're properly tuned.
02-16-2009, 07:40 PM
#5
Moderator
Join Date: Jan 2000
Location: Mercedes Norte, Heredia, Costa Rica
Posts: 20,981
Likes: 0
Received 9 Likes
on
8 Posts
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: cam question????
One of these?
You can use one if you want, but it's not necessary.
You can use one if you want, but it's not necessary.
Thread
Thread Starter
Forum
Replies
Last Post
