oil pressure sensor location!!! Help
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Jackson, TN
Posts: 485
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA
Engine: L98
Transmission: 700r4
Axle/Gears: 3.27 9bolt
oil pressure sensor location!!! Help
ok... I just put a another l98 in my car that someone had in there jeep.... (I spun a rod bearing in my orginal l98) and I didnt notice that they had screwed a cap onto the oil pressure fitting untill I was pluging sensors back up after i had EVERYTHING back together.
I have rounded it off trying to get it loose and it looks like my only option is going to be pulling the intake and drilling/taping the hole witch i DO NOT wanna do...
My question is I was trying to figure out if there was any other location I could use to screw the sensor into?
thanks
I have rounded it off trying to get it loose and it looks like my only option is going to be pulling the intake and drilling/taping the hole witch i DO NOT wanna do...
My question is I was trying to figure out if there was any other location I could use to screw the sensor into?
thanks
#3
Senior Member
Join Date: Feb 2010
Location: San Diego, California
Posts: 1,125
Likes: 0
Received 0 Likes
on
0 Posts
Car: Trailblazer EXT 4.2 (Firebird Form)
Engine: 5.1 4bbl
Transmission: 700R4 Mega Raptor Level 4
Axle/Gears: 2.73
Re: oil pressure sensor location!!! Help
ok... I just put a another l98 in my car that someone had in there jeep.... (I spun a rod bearing in my orginal l98) and I didnt notice that they had screwed a cap onto the oil pressure fitting untill I was pluging sensors back up after i had EVERYTHING back together.
I have rounded it off trying to get it loose and it looks like my only option is going to be pulling the intake and drilling/taping the hole witch i DO NOT wanna do...
My question is I was trying to figure out if there was any other location I could use to screw the sensor into?
thanks
I have rounded it off trying to get it loose and it looks like my only option is going to be pulling the intake and drilling/taping the hole witch i DO NOT wanna do...
My question is I was trying to figure out if there was any other location I could use to screw the sensor into?
thanks
#5
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Jackson, TN
Posts: 485
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA
Engine: L98
Transmission: 700r4
Axle/Gears: 3.27 9bolt
Re: oil pressure sensor location!!! Help
sweet thanks guys that worked good....
This motor is not looking so good. I had an adapter for the sensor and hooked it up, has good oil pressure but after I changed the oil and took it for a full throttle run it started knocking bad.
This motor is not looking so good. I had an adapter for the sensor and hooked it up, has good oil pressure but after I changed the oil and took it for a full throttle run it started knocking bad.
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
02-03-2019 12:21 AM
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM