New Combo
#1
Member
Thread Starter
Join Date: Mar 2003
Location: corsicana tx
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 camaro
Engine: 383
Transmission: 350 tci 3000 stall
Axle/Gears: 3.73
New Combo
383
Lunati sledge hammer crank
Scat 6in I beam rods 7/16 bolts
Srp -16cc invert dome
Dart pro1 200cc 64cc heads
custom 249/255 640/640 lift 110lsa solid roller
rpm airgap?
I know some are going to say I should of ran flat tops but I have had a pinging motor before and dont wanna push my luck! Im hoping maybe I can play with the head gaskets of something and get in the low 10:1 compression range? I have rpm airgap right now, I might try it and maybe go to a victor jr in the future. what you guys think.. should make a 11 sec street car!
Lunati sledge hammer crank
Scat 6in I beam rods 7/16 bolts
Srp -16cc invert dome
Dart pro1 200cc 64cc heads
custom 249/255 640/640 lift 110lsa solid roller
rpm airgap?
I know some are going to say I should of ran flat tops but I have had a pinging motor before and dont wanna push my luck! Im hoping maybe I can play with the head gaskets of something and get in the low 10:1 compression range? I have rpm airgap right now, I might try it and maybe go to a victor jr in the future. what you guys think.. should make a 11 sec street car!
#2
Supreme Member
Join Date: May 2001
Location: Pitman, NJ
Posts: 2,009
Likes: 0
Received 5 Likes
on
4 Posts
Car: '89 IROC-Z
Engine: Canfield 195 headed 358ci
Transmission: TH350, Art Carr 9.5"
Axle/Gears: 3.92 Dana 44
Re: New Combo
Ideally you should be able to run in the 10's N/A with a combo like that but even worst case scenario it should go into the mid 11's... I would bet the farm that it'd run best with a single plane though.
Thread
Thread Starter
Forum
Replies
Last Post
roysatikas
Transmissions and Drivetrain
0
09-22-2015 08:15 PM