Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!

Starter wiring?

Thread Tools
 
Search this Thread
 
Old 09-09-2022, 02:20 PM
  #1  
Member

Thread Starter
 
george88gta's Avatar
 
Join Date: Jan 2003
Location: Long Island N.Y
Posts: 380
Received 12 Likes on 12 Posts
Car: 1988 Pontiac GTA
Engine: 5.7 l98
Transmission: 700r4
Axle/Gears: BW 9bolt with torsen carrier
Starter wiring?

Good afternoon, so I finally got the 88 gta to my home after sitting in my grandmother's garage for Years.
I am trying to get the starter to work and could use some help
It's a power master starter.
I have 5 red wires, one yellow and one black coming from wire loom over passenger side valve cover. Also the main power coming from battery. One red wire is going to small post on starter . The main battery wire and other reds to large post on starter. The yellow wire going to a sensor? just forward of the starter. The one black is not connected to anything and seems to short to make it back to starter.
I jumped the to posts on starter and starter does run. Can anyone help out in figuring this out as I don't have a diagram of wiring? Thanks again!
Old 09-09-2022, 02:33 PM
  #2  
COTM Editor

iTrader: (22)
 
QwkTrip's Avatar
 
Join Date: Mar 2001
Posts: 9,932
Likes: 0
Received 1,860 Likes on 1,274 Posts
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: Starter wiring?

You can get all the wiring diagrams from '88 service manual here, https://www.thirdgen.org/forums/tech...ce-manual.html

This service manual will be invaluable as you own the car through the years.
Old 09-09-2022, 02:42 PM
  #3  
Member

Thread Starter
 
george88gta's Avatar
 
Join Date: Jan 2003
Location: Long Island N.Y
Posts: 380
Received 12 Likes on 12 Posts
Car: 1988 Pontiac GTA
Engine: 5.7 l98
Transmission: 700r4
Axle/Gears: BW 9bolt with torsen carrier
Re: Starter wiring?

Originally Posted by QwkTrip
You can get all the wiring diagrams from '88 service manual here, https://www.thirdgen.org/forums/tech...ce-manual.html

This service manual will be invaluable as you own the car through the years.
thank you , also correction one wire going to small post is purple, thought it was a dirty red . 😆
Old 09-09-2022, 02:53 PM
  #4  
COTM Editor

iTrader: (22)
 
QwkTrip's Avatar
 
Join Date: Mar 2001
Posts: 9,932
Likes: 0
Received 1,860 Likes on 1,274 Posts
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: Starter wiring?

Purple is the switch signal from the cab to turn the starter on/off.
The following users liked this post:
george88gta (09-09-2022)
Old 09-09-2022, 04:54 PM
  #5  
Member

Thread Starter
 
george88gta's Avatar
 
Join Date: Jan 2003
Location: Long Island N.Y
Posts: 380
Received 12 Likes on 12 Posts
Car: 1988 Pontiac GTA
Engine: 5.7 l98
Transmission: 700r4
Axle/Gears: BW 9bolt with torsen carrier
Re: Starter wiring?

Ok update and some useful info!
apparently I was wired correctly
as it turns out I replaced steering colum years ago and put the old key cylinder with chipped key taped inside it up in inside dash.
During my last computer prom update I did I disabled vats security.
as I sat I the garage for years at one point I went to straighten up some wiring under dash . I removed the key cylinder from under dash considering vats was disabled. Luckily I saved the cylinder because when I just reconnected it (two yellow wires) the starter worked!
so while stupidity was the culprit it's a good lesson learned!
Old 09-09-2022, 05:25 PM
  #6  
COTM Editor

iTrader: (22)
 
QwkTrip's Avatar
 
Join Date: Mar 2001
Posts: 9,932
Likes: 0
Received 1,860 Likes on 1,274 Posts
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: Starter wiring?

So, you're going to stick with the 2 key switch design, huh?
Old 09-09-2022, 06:40 PM
  #7  
Member

Thread Starter
 
george88gta's Avatar
 
Join Date: Jan 2003
Location: Long Island N.Y
Posts: 380
Received 12 Likes on 12 Posts
Car: 1988 Pontiac GTA
Engine: 5.7 l98
Transmission: 700r4
Axle/Gears: BW 9bolt with torsen carrier
Re: Starter wiring?

Originally Posted by QwkTrip
So, you're going to stick with the 2 key switch design, huh?
lol well she's been in the garage for years and finally got her started probably first time in 6 years.. guess it's time to figure out how to remedy that situation lol
overall there was definitely a smile when she started and ran well after sitting all that time!!!!!!
I still don't know where the black wire goes. Guessing I will just ground it till I get my diagrams with proper location...
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
IROC216
Electronics
3
09-27-2012 09:09 AM
wwwyzzerdd
Tech / General Engine
2
07-13-2011 10:29 PM
Dirtbik3r
Electronics
7
01-07-2006 03:19 PM
65panhed
Electronics
2
01-01-2004 08:21 PM



Quick Reply: Starter wiring?



All times are GMT -5. The time now is 03:28 PM.