Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I have a tech 1 scanner which shows the counts. Now I have never used this feature yrt. What should it read at idle and when i rev it up and let it come down should it hit teh same count as idle or go like -2 then come to the count for idle?
you may want to check the fuel pressure regulator diaphram. if it's leaking the high vacuum when caused by the rev down can suck fuel passed the regulator if there is a problem with the diaphram. i've ran into this problem before. also a problem with the minimum air setting can cause problems. what is the block learn numbers showing when this happens?
Heres the scoop. The FP at idle is 43PSI and 47PSI line disconnected. The FP at idle used to be 38 last year but over the winter I put in a new Walbro 255 unit and the pressure seems to be higher. blm's are 126/129 idle reved up and come down are 119/135 this is after a TF head swap and a Xtreme cam. I'm running the stock chip still.
Originally posted by Mkos1980 Heres the scoop. The FP at idle is 43PSI and 47PSI line disconnected. The FP at idle used to be 38 last year but over the winter I put in a new Walbro 255 unit and the pressure seems to be higher. blm's are 126/129 idle reved up and come down are 119/135 this is after a TF head swap and a Xtreme cam. I'm running the stock chip still.
don't know the size of your cam but, it is idle searching. you might be surpassing the stock chip's capability with the cam. the cam too large for stock programming so it is idle searching.
i'd agree, that's alot of cam with a stock chip to have no idle problems. do you have any numbers with the t.p.s reading at idle and mass air flow numbers at just a normal idle?
I know I am surprised. In Closed loop its 128/127 BLMs Smooth idle at 750 . TPS is .54 I havent checked the MAF Yet. Its brand new but i'll get the readings tomororw. But man does it Haul.
