stealth ram clone for hood clearance
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: loxahatchee fla
Posts: 564
Likes: 0
Received 0 Likes
on
0 Posts
#2
Senior Member
Join Date: Mar 2001
Location: LONGVIEW TX . USA
Posts: 953
Likes: 0
Received 0 Likes
on
0 Posts
Now that is schweet I was going to make something like that to get over the very long tubes of the ltr setup.
I have also seen the basicly same setup but he used the stock plenum but made covers for the long tube setup and milled the bottom of the thing flat and put the holes for the air to flow into the base.
I have also seen the basicly same setup but he used the stock plenum but made covers for the long tube setup and milled the bottom of the thing flat and put the holes for the air to flow into the base.
#3
TGO Supporter
iTrader: (2)
There's a thread on corvetteforum.com about that too. Another alternative might be to use the plenum from the street & Performance big block setup. It looks just like a stock TPI plenum, except that it sits on top of a Tunnel Ram EFI base.
EDIT: Here's a thread I started on chevytalk.org that covers what I'm thinking:
http://www.chevytalk.org/forums/Foru...ML/000726.html
EDIT: Here's a thread I started on chevytalk.org that covers what I'm thinking:
http://www.chevytalk.org/forums/Foru...ML/000726.html
Last edited by Jim85IROC; 06-20-2002 at 08:43 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post