Seeking opinions.
09-10-2008, 10:36 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Round Lake Beach Il
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Trans Am... 92 25th RS
Engine: TPI 350 .03 over ported lower&bowls
Transmission: 700R
Axle/Gears: 2:73
Seeking opinions.
Hey folks. I have been running the fresh motor all summer its silky and strong. Recently i have noticed idle problems here and there, also luke warm hard starting. Investigation showed two injectors with very low resistance. I replaced all the injectors when i built the thing with obviously poor quality units as this is the second problem i have had with them. They are still warranted but i do not want to go through this project again needlessly. What injectors seem to be on the higher side of reliability?
09-11-2008, 10:04 AM
#2
Senior Member
iTrader: (1)
Join Date: Sep 2003
Location: St. Louis, Missouri
Posts: 988
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Firebird Formula
Engine: 383 Stealth Ram
Transmission: 700R4
Axle/Gears: 3.73 9 bolt Posi
Re: Seeking opinions.
If you do a quick search, most people like ford injectors. I use them and have had no problems.
09-11-2008, 10:19 AM
#3
Supreme Member
iTrader: (3)
Join Date: Oct 2005
Location: Cincinatti OH
Posts: 1,833
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 L03 700r4 RS
Engine: 1987 WS6 Trans AM Lb2
Transmission: Th350 red neck Performance 3k stall
Axle/Gears: 95 Mustang 8.8 built with 3.73s
Re: Seeking opinions.
LS1 injectors and never look back.
09-12-2008, 12:02 AM
#4
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Round Lake Beach Il
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Trans Am... 92 25th RS
Engine: TPI 350 .03 over ported lower&bowls
Transmission: 700R
Axle/Gears: 2:73
Re: Seeking opinions.
I did a search. Some people do like ford injectors, but a search on such a matter brings endless results. Its why I was seeking opinions. Thanks for yours, It seems a good bet. Has to beat the hell outa what I have going on at the moment...
09-12-2008, 07:53 AM
#5
Senior Member
iTrader: (1)
Join Date: Sep 2003
Location: St. Louis, Missouri
Posts: 988
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Firebird Formula
Engine: 383 Stealth Ram
Transmission: 700R4
Axle/Gears: 3.73 9 bolt Posi
Re: Seeking opinions.
No problem. After my factory injectors went bad, I used Accel ones for a while... they only lasted about a year before they began failing! My advice is to stay away from Accel. Just my 2 cents.
Hope this helps!
Hope this helps!
09-12-2008, 09:52 AM
#6
Senior Member
Join Date: Sep 2007
Location: West Central Ohio
Posts: 1,091
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 vette
Engine: 383
Transmission: 700R4
Axle/Gears: 3.07
Re: Seeking opinions.
Hey folks. I have been running the fresh motor all summer its silky and strong. Recently i have noticed idle problems here and there, also luke warm hard starting. Investigation showed two injectors with very low resistance. I replaced all the injectors when i built the thing with obviously poor quality units as this is the second problem i have had with them. They are still warranted but i do not want to go through this project again needlessly. What injectors seem to be on the higher side of reliability?
What kind of injectors, did you have and what kind, do you have now?
Just wondering, so not to travel your unfortunate path.
I run the ford design II
09-14-2008, 04:32 PM
#7
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Round Lake Beach Il
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Trans Am... 92 25th RS
Engine: TPI 350 .03 over ported lower&bowls
Transmission: 700R
Axle/Gears: 2:73
Re: Seeking opinions.
Well....... I let one of my suppliers talk me into trying his remans. You see how it turned out he reimbursed me but the labor is a fall as well as a PITA. The company is Uremco........ I wouldn't recommend it.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Darth Mole
Tech / General Engine
2
09-21-2015 09:48 AM
