LS1 T56 on SBC 350?
03-23-2010, 11:23 PM
#1
Member
Thread Starter
Join Date: Mar 2010
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
LS1 T56 on SBC 350?
Ok a friend of mine can get a 6 speed out a LS1 car and hes wondering if its possible to use this with a SBC and if so what would need to be changed to make it work.
Thanks
Thanks
03-24-2010, 06:17 AM
#2
Senior Member
iTrader: (2)
Join Date: Aug 1999
Location: Elkton MD, USA
Posts: 858
Likes: 0
Received 5 Likes
on
3 Posts
Car: 1985 Camaro Z28, VIN F
Engine: 427 sbc, HSR
Transmission: T-56, self rebuilt 700+ hp
Axle/Gears: Moser 12bolt, 3.42 trutrac
Re: LS1 T56 on SBC 350?
Either get an adapter plate and run it with a Muncie/T5/T10 clutch/bell setup
http://www.thegearbox.org/catalog/it...17/4803441.htm
Or swap over the bellhousing/mid-plate/input-shaft from an LT1 T56 and mount it directly. Would use LT1 clutch setup and either a stock LT1 or conversion flywheel depending on RMS
http://www.thegearbox.org/catalog/it...17/4803441.htm
Or swap over the bellhousing/mid-plate/input-shaft from an LT1 T56 and mount it directly. Would use LT1 clutch setup and either a stock LT1 or conversion flywheel depending on RMS
06-11-2013, 02:29 PM
#3
Junior Member
Join Date: Apr 2010
Location: Premont Tx
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro rs
Engine: 355 sbc
Transmission: muncie m22
Axle/Gears: 10 bolt limited slip 373's
Re: LS1 T56 on SBC 350?
Either get an adapter plate and run it with a Muncie/T5/T10 clutch/bell setup
http://www.thegearbox.org/catalog/it...17/4803441.htm
Or swap over the bellhousing/mid-plate/input-shaft from an LT1 T56 and mount it directly. Would use LT1 clutch setup and either a stock LT1 or conversion flywheel depending on RMS
http://www.thegearbox.org/catalog/it...17/4803441.htm
Or swap over the bellhousing/mid-plate/input-shaft from an LT1 T56 and mount it directly. Would use LT1 clutch setup and either a stock LT1 or conversion flywheel depending on RMS
Hey about that adapter plate...I see you would use the same bell housing clutch and clutch linkage for your muncie setup....so does that mean you use the same flywheel also from your old set up
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
Eric-86sc
Engine/Drivetrain/Suspension Parts for Sale
0
08-24-2015 09:01 PM
