700 R4 shift shaft for an automatic
#1
Junior Member
Thread Starter
Join Date: Aug 2017
Location: Virginia
Posts: 39
Received 0 Likes
on
0 Posts
Car: 1988 Camaro IROC Z
Engine: 427 Stroker
Transmission: 700 R4
Axle/Gears: Moser Street axles and 410 Yukon
700 R4 shift shaft for an automatic
What's good everybody My
shift shaft is loose goes in and out of the transmission about a quarter of an inch if it moves out 1/4 inch you cannot get 2nd and 1st gear if you push it back in flush with the case you get 1st and 2nd gear is there something that holds it tight against the housing on the inside of the transmission how would you replace that and can you fix that without dropping the transmission
shift shaft is loose goes in and out of the transmission about a quarter of an inch if it moves out 1/4 inch you cannot get 2nd and 1st gear if you push it back in flush with the case you get 1st and 2nd gear is there something that holds it tight against the housing on the inside of the transmission how would you replace that and can you fix that without dropping the transmission
Thread
Thread Starter
Forum
Replies
Last Post
my90firebird
Firebirds for Sale
3
02-16-2016 04:15 PM
project89
Transmissions and Drivetrain
5
07-14-2014 11:27 PM
Matt Bane
Engine/Drivetrain/Suspension Wanted
3
12-19-2009 10:11 AM