centercaps
Thread Starter
Junior Member
Joined: Oct 2001
Posts: 33
Likes: 0
From: Warsaw, Poland
Car: IROC 5,0 TPI '88
Engine: 305 TPI
Transmission: auto
centercaps
Hi!
Im owner IROC '88
Problem is : Not long time ago I have lost one of my centercap :[
maybe Anybody know where can I buy so-that
( set or one piece )?
maybe is possible buy this on internet
( visa, billpoint, bidpay ) in USA??
best regards!
Gregory - POLAND
Im owner IROC '88
Problem is : Not long time ago I have lost one of my centercap :[
maybe Anybody know where can I buy so-that
( set or one piece )?
maybe is possible buy this on internet
( visa, billpoint, bidpay ) in USA??
best regards!
Gregory - POLAND
Junior Member
Joined: Jun 2001
Posts: 59
Likes: 0
From: Concord, CA
Car: 89 IROC
Engine: 5.7 TPI
Transmission: A4
Thread Starter
Junior Member
Joined: Oct 2001
Posts: 33
Likes: 0
From: Warsaw, Poland
Car: IROC 5,0 TPI '88
Engine: 305 TPI
Transmission: auto
OK - look this www.fbody.org.pl
.... simply - we have in *** european cars
[This message has been edited by greg_pl (edited October 19, 2001).]
.... simply - we have in *** european cars

[This message has been edited by greg_pl (edited October 19, 2001).]
Trending Topics
irocs in PL
)) how can we afford HAHAthat a good Q
when the car i brouhgt to Poland it costs twice as much than in US.
than the gas cost 3/4 of US dollar for 1 litre.

and the parts costs......... mhm min 2 times as much....
so that sux.
but some can even afford a C5 , mhm some of them are even
are even modyfing them.
we have great meeting s here
check out my site
http://www.jarek.arjmm.pl/galeria/zlot/1/
http://www.jarek.arjmm.pl/galeria/zlot/2/
http://www.jarek.arjmm.pl/galeria/zlot/3/
http://www.jarek.arjmm.pl/galeria/zlot/4/
http://www.jarek.arjmm.pl/galeria/zlot/5/
pictures from 2001 meeting
http://www.jarek.arjmm.pl/filmy3/fuel.mpg
movie from 2001 meeting
Originally posted by Lostsol
I replaced all mine with 1/4" Smoke Plexiglass, on both my 89 Irocs and my GTA wheels. 1/8" on the GTA's though. Works for me, and a damn site cheaper, and I like the subdued look.
I replaced all mine with 1/4" Smoke Plexiglass, on both my 89 Irocs and my GTA wheels. 1/8" on the GTA's though. Works for me, and a damn site cheaper, and I like the subdued look.
GM wanted somewhere around $100 and then like $10 a decal. I got them aftermarket for $50 for the set and decals, but it was a local dealer, "Corvette Mystique". He probably ordered'm through classic industries though, he gets a lot of stuff through them. It works out because I don't have to pay shipping, because he just picks it up with another order. Really though, in the long run you should get new rims. My centercaps were stolen once, all 4, and I lost another one that must have fallen off a few monthes back and had to replace it. They just pop right off. I wish someone would have made some that fit under the lugnuts, so you can't just pop them off. That's really not a bad looking set of rims, but they're too costly to replace that cap.
Mathius
Mathius
Thread
Thread Starter
Forum
Replies
Last Post





