What kind of fin is this?
What kind of fin is this?
Someone gave me this fin and said it was for a camaro, but when I tried to put it on the bolt holes didn't line up and it is about 1/2 inch shy on either side of covering the hatch. I think it may be off a 88 from what I've read here. Any ideas ?
Last edited by 86IROC305; Feb 19, 2002 at 07:50 PM.
Trending Topics
I have that. Its the only wing on a 3G car that I actually dislike, go figure its the one that came on the car I ended up with. It looks good from a couple angles but I don't like how it makes the lines of the car look from the back at all, and its a little too small. When budget permits I'm jumping on the 91-92 Z wing bandwagon since that won't require as much drilling and I really like the way it looks from the sides.
Here's a picture from this summer right after I gotthe cat back put on but before the rear blackouts (which really cleaned up the lines of the car quite a bit from the back). My apologies to 56Kers!
Here's a picture from this summer right after I gotthe cat back put on but before the rear blackouts (which really cleaned up the lines of the car quite a bit from the back). My apologies to 56Kers!
Thread
Thread Starter
Forum
Replies
Last Post
Gunner242
Electronics
7
Dec 25, 2015 04:49 PM






Maybe I can find someone who wants to trade for a hi-rise (doubtful
) or for something else I need. 