door sill options??
Joined: Jul 1999
Posts: 1,421
Likes: 24
From: Stavanger area, Norway
Car: 86 IROC Convt
Engine: 305TPI
Transmission: TH700R4
I have never seen any, but that sure would be nice!!
One would think that someone makes them as there are plenty available for trucks, vettes etc.
Im interested in hearing about this as well!
Ken
One would think that someone makes them as there are plenty available for trucks, vettes etc.
Im interested in hearing about this as well!
Ken
Supreme Member
Joined: Apr 2000
Posts: 1,451
Likes: 0
From: Virginia Beach, VA, USA
These guys make fourth gen aluminum door sills - I don't know if they'd fit a third gen; give 'em a call to see if they know. If you do find out, post it back here.
S.
S.
Joined: Jan 2001
Posts: 3,188
Likes: 59
From: Conroe, TX
Car: 1987 GTA
Engine: LS1
Transmission: 4L60e
fatal88 had some custom made. But I asked him at the Houston meet if he could get me their number....it was a long time ago. They probably don't even have the molds anymore.
most of the ones used on 4thgens are rather thin sheet metal basically that has been bent to form....
of course one with the right knowledge and a little skill cut cut and fit such an item to fit!
i'm going to look into it starting monday as i desperatly need something that can extend out a little further. i'll have to take a good look at stock 4thgen and vette sills to be sure though.
if anyone knows please post....otherwise once i'm done i'll be sure to relay it to all of you.
of course one with the right knowledge and a little skill cut cut and fit such an item to fit!
i'm going to look into it starting monday as i desperatly need something that can extend out a little further. i'll have to take a good look at stock 4thgen and vette sills to be sure though.
if anyone knows please post....otherwise once i'm done i'll be sure to relay it to all of you.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
