my question is i have a white 91 camaro with the stock side door moldings down the center of the doors and i want them gone but i dont really want to mess up the paint to much is there anyone that has done this is there anywhere i can do this any help would be much appriceted thanks

 

Fishing line and Gum&Tar Remover

Beware your paint is likely to mismatch because the area under the moldings was not hit by the sunlight for the years

 

Use a hair dryer to heat the glue first to help soften it.

 

In the middle of the day when the car has warmed up nicely on the outside, just start pulling from one end and pull it off slowly making sure to get as much gunk off with the molding as possible, it's really just double sided tape. The paint shouldn't come off with the strip unless you do this on a really cold day or it's already in bad condition. Fishing line may work too, I'd just use it to get the edge up though. There's many ways to do it, just takes a little care. The only given is that you will need some gunk remover.

 

i'm looking for some, if they aren't damaged will you sell them to me? pm and let me know. thanks.

 

anyone have moldings laying around they don't want on their car?

 

come on guys... someone must have a set that don't want.

 

Had some junk ones I pulled off my old car. Had to go.....in the trash.