Need a measurement
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 18
Likes: 0
From: South Dakota
Car: 1988 and 1989 IROC_Z
Engine: 350 TPI w/ chip & 305 TPI
Transmission: 700R4
Axle/Gears: 2.77
Need a measurement
I need a measurement from the back of the quarter panel corner to corner in the picture at the rear hatch points. yeah i got hit in the rear 
Last edited by andyda98; May 9, 2010 at 11:10 PM.
Banned
iTrader: (12)
Joined: Jul 1999
Posts: 12,212
Likes: 13
From: Bertram (outside Austin), TX
Car: 87 GTA
Engine: L98
Transmission: 700R4
Axle/Gears: Dana M78 3.27 posi
Re: Need a measurement
52 5/8", edge to edge, on my 87 GTA. If you are making a new hatch piece to fit in there? I wouldn't go over 52 3/8", to allow room for flex & for no rubbing.
EDIT:
Looks like you got rear ended though & need to pull it back out, huh?
EDIT:
Looks like you got rear ended though & need to pull it back out, huh?
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 18
Likes: 0
From: South Dakota
Car: 1988 and 1989 IROC_Z
Engine: 350 TPI w/ chip & 305 TPI
Transmission: 700R4
Axle/Gears: 2.77
Re: Need a measurement
its to pound it out a little and to see if my fenders got moved, i don't think they did, i am cuting a body panel off another car-- thanks i was at 52 even almost when i measured
Last edited by andyda98; May 9, 2010 at 11:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM