Searched with little luck. Can lift the rear end with no problem, not sure to lift from the front and apparently neither can someone else. Got my car back and found that the bottom of my fender is crushed inwards and also bowed out my fender.

If someone could show me where to lift the front, I'd appreciate it.

 

yeah the standard pinch welds on these cars are fairly useless (especially if its not rust free) because they always buckle. and it depends on the type of lift you use. when i do it, im using a lift where the lift arms swing in from the sides. and i have to jack up the front to set the lift arm so it clears the exhaust to get to the "body rail"

 

Okay, I'll see how that works because the lift I would use is the same type.

 

There is a sticky in suspension section called suspention 101. Has the jack point layed out there