Replaced triangle seals...still a lot of wind noise?
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2009
Location: Stoughton, MA
Posts: 817
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro Z28
Engine: 305 5.0 V8 carburated
Transmission: 700r4
Replaced triangle seals...still a lot of wind noise?
As the title says, I have a lot of wind noise even after replacing the triangle seals! They just don't seem to seal right to the window, and when I close the door they push in the weatherstipping along the a-pillar a bit. On the triangle seals, which way do they go? Should the side that has more go inside the window or outside? I installed them as the old ones came off. Maybe they were wrong before? I'll post pics if it's confusing. I'm not the best at describing.
Other than that, is is just the shape of the car that causes an unavoidable amount of wind noise?
Other than that, is is just the shape of the car that causes an unavoidable amount of wind noise?
#2
Supreme Member
iTrader: (4)
Join Date: Mar 2009
Location: Pepperell, MA
Posts: 3,079
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: Replaced triangle seals...still a lot of wind noise?
sometimes these windows get wobbly over time too, so you may need to get into the door and adjust the window itself to get it resting just right against the roof rail seal too
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2009
Location: Stoughton, MA
Posts: 817
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro Z28
Engine: 305 5.0 V8 carburated
Transmission: 700r4
Re: Replaced triangle seals...still a lot of wind noise?
I thought that would be the case. How do I go about adjusting the window?
#4
Supreme Member
iTrader: (4)
Join Date: Mar 2009
Location: Pepperell, MA
Posts: 3,079
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: Replaced triangle seals...still a lot of wind noise?
there are some really good photos and adjustment info here:
https://www.thirdgen.org/forums/body...dow-loose.html
https://www.thirdgen.org/forums/body...dow-loose.html
#5
Senior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2009
Location: Stoughton, MA
Posts: 817
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro Z28
Engine: 305 5.0 V8 carburated
Transmission: 700r4
Re: Replaced triangle seals...still a lot of wind noise?
I might take it apart again today and see if I can adjust everything. If not I'll snap some pics to show you guys what i'm talking about!
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM
Fronzizzle
Suspension and Chassis
6
03-18-2019 08:29 PM