Underdash panel
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 623
Likes: 2
From: Hard hittin' New Britain, CT USA
Underdash panel
I have an 85 Iroc-Z. I'm missing the panel that goes under the dash on the drivers side. It's down right above the pedals and it covers all the wires and has a hole for the floor light. Will any panel from any 82-92 camaro fit? Would a firebird panel fit? What will fit?
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 623
Likes: 2
From: Hard hittin' New Britain, CT USA
Thanks alot man. Good luck trying to find it, I know I've been searching for a little while. All my friend's cars are missing it too. I'm starting to think that these cars came stock with no panel and a defective power trunk
I would check the local junk yards, I got a pair out of an 84 Z28, I haven't put them in yet because I think they would look dumb since I don't have the lights. do you guys know any way I could put the factory lights in the make them work.
Yeah mine aren't there either
But I think it's cuz I have a converted car and the LHD ones won't fit
Damn eh
------------------
Nobody ever got cancer from smoking tires!
gibsandwich@hotmail.com
Get ICQ Page My ICQ
ICQ # 18562788
------------------
1982 Z28 Camaro
305ci LG4, Muncie 4-Speed, Holley Carburettor (CFM Unknown), 2.5" Stainless steel exhaust all the way through.
Fibreglass hood.
Boston 4x6" CX7e 2-ways, 6x9" Nippon America (no-name?) 3-ways
Other stuff I haven't figured out yet.
But I think it's cuz I have a converted car and the LHD ones won't fit
Damn eh
------------------
Nobody ever got cancer from smoking tires!
gibsandwich@hotmail.com
Get ICQ Page My ICQ
ICQ # 18562788
------------------
1982 Z28 Camaro
305ci LG4, Muncie 4-Speed, Holley Carburettor (CFM Unknown), 2.5" Stainless steel exhaust all the way through.
Fibreglass hood.
Boston 4x6" CX7e 2-ways, 6x9" Nippon America (no-name?) 3-ways
Other stuff I haven't figured out yet.
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
Hmm. All 4 of my thirdgens had both panels. Guess you guys are just lucky. 
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
Custom Thirdgen Subwoofer Enclosures
"I didn't know a bored out Ford could go so slow" -Shenandoah

------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
Custom Thirdgen Subwoofer Enclosures
"I didn't know a bored out Ford could go so slow" -Shenandoah
Trending Topics
Moderator




Joined: Mar 2001
Posts: 14,293
Likes: 195
From: Doghouse ······································ Car: 1989 Formula 350 Vert Engine: 350 L98 Transmission: 700R4 Axle/Gears: B&W 3.27
Car: 87 Formula T-Top, 87 Formula HT
Engine: 5.1L TPI, 5.0L TPI
Transmission: 700R4, M5
Axle/Gears: Sag 3.73, B&W 3.45
I would think the Firebird panel MIGHT fit, I do not know what they wold change on the cars to make it different, but it might be worth a shot if you cannot find a Camaro one.
John
John
Not that I am an expert but I don't belive that all of them came with the panels. Mine didn't and the courtisy lights were mounted on a small bracket atached to the side panel trim piece, where as the covers have acut out for the courisy lights buit into them. I only noticed as I broke the small braket when I went to install the panels I retrived form a junk yard. Maybe it was beacuse of the Bose speaker option???
They are differnet between the automatic and 5 speed and maybe the computer cut out.
They are differnet between the automatic and 5 speed and maybe the computer cut out.
Thread
Thread Starter
Forum
Replies
Last Post
formula00ra
Interior Parts Wanted
1
Sep 28, 2015 11:50 AM





