Brake line conversion Dbl flare to Iso?
#1
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: Poconos, Pa
Posts: 287
Received 0 Likes
on
0 Posts
Car: 1984 Firebird
Engine: LT1
Transmission: T5
Axle/Gears: 3.42's
Brake line conversion Dbl flare to Iso?
Hey,
I'm sorry if this has been asked before, but I'm unsure how to even search for this topic.
I have an '84 Firebird, which, to the best of my knowledge, uses double flares for the brake lines.
I just bought brakes off of a 98 Camaro (LS1 swap) and would like to use these brakes.
How exactly would I go from the double flare at the junction (rear axle) to the calipers? Is there some kind of adapter?
What about for the fronts??
Thanks!!!
I'm sorry if this has been asked before, but I'm unsure how to even search for this topic.
I have an '84 Firebird, which, to the best of my knowledge, uses double flares for the brake lines.
I just bought brakes off of a 98 Camaro (LS1 swap) and would like to use these brakes.
How exactly would I go from the double flare at the junction (rear axle) to the calipers? Is there some kind of adapter?
What about for the fronts??
Thanks!!!
#4
Member
iTrader: (2)
Join Date: Jul 2005
Location: Bloomingdale, NJ
Posts: 459
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Z28
Engine: 350
Transmission: T-5 5 Spd
Axle/Gears: Built 10bolt w/3.73s
I replaced everything in the rear of my '85 Z28 and am in the process of replacing the front and I believe its all ISO bubble flare. Still not sure if and what adapters you may or may not need. The LS1 thread didn't cover this?
#5
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: Poconos, Pa
Posts: 287
Received 0 Likes
on
0 Posts
Car: 1984 Firebird
Engine: LT1
Transmission: T5
Axle/Gears: 3.42's
I just looked at the LS1 tech article, and that was vague about what years had double flares, and what had iso.. thanks though..
#6
Member
Join Date: Aug 2004
Location: Miami, FL
Posts: 298
Likes: 0
Received 1 Like
on
1 Post
Car: '85 TA
Engine: Carb'd 350, ported 416s
Transmission: retrofitted T5
Axle/Gears: 3.42 7.62" 10-bolt, locker
I just replaced a wheel cylinder in my '85 and it had ISO bubble flares. But when I took one off my '84 junker, it had double flares. Howerver, the junker car was heavily modified before I got a hold of it (IE: 28 spline axles and no emergency brake hardware, even inside the drums), so thats still not really conclusive. From what I have seen between the two cars, there are alot of minor changes that took place between '84 and '85 like that.
Thread
Thread Starter
Forum
Replies
Last Post