90-92 Compressor Brace
08-15-2018, 10:25 AM
#1
90-92 Compressor Brace
I'm interested in the compresssor's driver's side brace, which extends from the compressor to just below the thermostat housing. Is the brace fastened to the manifold by the stud/bolt set-up you see or does the brace fit flush on the manifold?
Last edited by JamesC; 08-15-2018 at 10:37 AM.
08-15-2018, 01:03 PM
#2
Supreme Member
iTrader: (11)
Join Date: Sep 1999
Location: NJ
Posts: 4,345
Received 298 Likes
on
234 Posts
Car: 92 Firebird
Engine: 4.8 LR4
Transmission: T56
Axle/Gears: 3.45 9 Bolt
Re: 90-92 Compressor Brace
This is how my 88 was, not sure if 90-92 was different?
edit, oops you must not have a TPI setup?
edit, oops you must not have a TPI setup?
Thread
Thread Starter
Forum
Replies
Last Post
82tarecaro
Engine/Drivetrain/Suspension Wanted
14
03-17-2013 10:19 AM
KED85
V6
8
06-27-2002 10:42 AM