I applied the patch to get the VE tables extended to 6400RPM and am using the correct ecu file to recognize the new table. However in TunerPro the new table will not save any changes???

 

send me the bin and ecu.

mmansur at hotmail

 

you have mail

 

Patch to V3.06?

 

the stuff you sent works fine. can you try again and verify that theres actually a problem, and if so, be absolutely specific as to what it is and how to make it happen?

 

Edit this table.....Volumetric Efficency vs. RPM vs. MAP (Extended) I save it and close reopen and the values are not changed????

 

they sure are. no idea whats up on your end. are you sure you actually changed the value in the table to begin with?

 

ok whats happening is that it will not save anything pasted into it from excell. I am trying to transfer my VE data from another table into this bin...

 

aaah. i'll look into that. new feature. there has to be bugs or the feature would suck. :-D

 

Thanks

 

nope. that works too. here's what i did (successfully):

1) open the extended table.
2) right click -> copy table to clipboard
3) go to excell, paste table
4) make changes in excel
5) select the entire table in excel, then copy to clipboard from excel
6) back to tunerpro, right click on the table -> paste from clipboard
7) click save (table closes)
8) open the table again. changes are still there.
9) for gits and shiggles, save the bin to file, close tunerpro, reopen tunerpro, open the table. changes still there.

 

Ok gonna give that a try

 

I must be retarded cus I cant get it to work

 

one of us might be.

1) what happens when you edit a different table using the same method?
2) what happens when you edit a table in tunerpro without the copy/paste stuff?
3) what happens if you open the 6Ev011 ecu file and apyp/arap bin and edit a table?
4) what about constants/flags?

anyone else see this issue?

m

 

1) Using the same method it will not save.
2) Without the copy and paste it will save fine
3)Using the copy paste stuff in the 6Ev011 ecu file and arap bin it will NOT save.
4) flags save fine.

I am using XP and Office XP?????

 

are you copying the entire table in excel (click on the upper left cell, shift-click on the lower right cell, then select copy)?

when you paste into tunerpro, can you confirm that the changes are there before you click save? maybe make drastic, ridiculous changes just so they're obvious?

Its working fine and dandy for me.

 

Sorry to waste you time....I must have messed up the conversion factor on one of the tables by mistake...