Enough voltage?
Thread Starter
Supreme Member
iTrader: (2)
Joined: Nov 2001
Posts: 1,602
Likes: 0
From: Lakewood, CO
Car: 1994 Jeep Wrangler
Enough voltage?
for you guys using the DTR pin on your home made cables to power them, did you have exactly 12 volts? I just checked mine w/ a volt meter and was getting ~8.73 DC volts is this enough or do I need to tap into the car's power?
Supreme Member
iTrader: (1)
Joined: Jan 2002
Posts: 4,432
Likes: 1
From: garage
Engine: 3xx ci tubo
Transmission: 4L60E & 4L80E
That should be fine. It is usually the negative swing where the problem occurs. Is this a MAX-232 setup or a two transistor.
Don't run a two transistor on a LT1 PCM.
J
Don't run a two transistor on a LT1 PCM.
J
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM