New to tuning
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 36
Likes: 2
New to tuning
im new to tuning. I have read for a week now or so and I got the logist of it. Any help will be appreciated. I have 1991 Pontiac firebird. I installed a truck 350 tbi motor. I used my 700 transmission. Installed a 2000 stall. Open long tube headers into a 3 inch cherry bomb. I installed a gu6 g80 from a 2001 into it. So speed mph is way off. I have a 7747 ecu.
so what to do next.
so what to do next.
Joined: Dec 2004
Posts: 16,737
Likes: 994
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: New to tuning
Some good reading on $61 mask
https://www.thirdgen.org/forums/diy-...uide-book.html
https://www.thirdgen.org/forums/diy-...uide-book.html
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 36
Likes: 2
Re: New to tuning
I purchased autoprom from Moates. The whole kit and g2 adapter. I soldered in adaptor myself. Anyway. I used for monitoring work perfect. I used $42. Definitions. the problem when I went to emulate. I hooked up everything. Car running fine. Then ribbon cable from ecu to autoprom started smoking. I unhooked very quickly. I found far wire opposite of red striped wire is then one that got hot. I got my factory asdu chip back in adapter. Which was a task. But I got back in and car runs fine. I can still monitor. I have contacted Moates theee times about it with no response. I will buy new cable. I know this is do at your own risk. But I’m not sure there isn’t something else wrong. So I have another 7747 board. And a computer buddy. That does nothing but soldering chips in. So I’m taking new board to him to solder. But man my solders looked perfect. He agreed (computer guy). But I am much bigger than him so maybe he just said that lol.
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 36
Likes: 2
Re: New to tuning
I purchased autoprom from Moates. The whole kit and g2 adapter. I soldered in adaptor myself. Anyway. I used for monitoring work perfect. I used $42. Definitions. the problem when I went to emulate. I hooked up everything. Car running fine. Then ribbon cable from ecu to autoprom started smoking. I unhooked very quickly. I found far wire opposite of red striped wire is then one that got hot. I got my factory asdu chip back in adapter. Which was a task. But I got back in and car runs fine. I can still monitor. I have contacted Moates theee times about it with no response. I will buy new cable. I know this is do at your own risk. But I’m not sure there isn’t something else wrong. So I have another 7747 board. And a computer buddy. That does nothing but soldering chips in. So I’m taking new board to him to solder. But man my solders looked perfect. He agreed (computer guy). But I am much bigger than him so maybe he just said that lol.
Thread
Thread Starter
Forum
Replies
Last Post
327_TPI_77_Maro
DIY PROM
5
Nov 20, 2004 05:06 PM
GASGZLR
Carburetors
2
Feb 28, 2004 03:15 PM