Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

VATS problem or not?

Old Nov 6, 2000 | 07:25 PM
  #1  
Yam's Avatar
Yam
Thread Starter
Junior Member
 
Joined: May 2000
Posts: 32
Likes: 0
From: Miami, FL
VATS problem or not?

Every now and then my car wont start but I'm not sure if it's a VATS problem or not. I put the key in, the security light comes on for 1-2 secs and then goes out. I try to start the car but get nothing. I replaced the starter because I thought it might have been that. Replace the battery too.
The only things I can think of is the VATS or maybe heat soak to the starter solenoid as it seems to do it only when I have driven the car.
Reply
Old Nov 7, 2000 | 11:03 AM
  #2  
Tim Burgess's Avatar
Supreme Member
 
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
If the security light comes on for a few seconds & then goes off, then the VATS system should be enabling the start relay.

Tim
Reply
Old Nov 7, 2000 | 12:53 PM
  #3  
thunderstick's Avatar
Supreme Member
 
Joined: Jun 2000
Posts: 1,295
Likes: 0
From: VA
Car: '91 Z28
Engine: L98 5.7L TPI
Transmission: 700R4
Axle/Gears: 323's
I had that phantom "no-start" myself - for about 4-5 months. Last time it happened, it didn't want to start at all and I was getting really pissed... Anyhow, I reached under the car to the starter wiring and it seemed loose, jiggled it around and the car started right up. When I got home and let it cool down a bit, I checked all the connections and it all seemed to be tight and I was like WTF?. So what I ended up doing was to disconnect all the wiring at the battery, starter, and grounding points and cleaned up everyone of the terminals with a wire brush. Haven't had any problems since. (but I will tell you I screwed up and forgot to put the fuse back in my starter cut-out on my alarm when I did all that and then I was REALLY pissed off. I thought I really messed something up and then I remembered I left it out - silly me...)

KAM
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GeneralIesrussi
Carburetors
6
Jun 20, 2024 07:21 PM
db057
TBI
14
Apr 28, 2019 07:45 AM
andy74
Electronics
2
Sep 3, 2015 08:41 AM
GeneralIesrussi
Tech / General Engine
0
Sep 3, 2015 03:23 AM
greenyone
TPI
3
Sep 2, 2015 03:39 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 08:39 AM.