I have an Air/Fuel ratio gauge and I need to know the best way to mount it. I have a 92 Camaro and I cant find a good place to go through the firewall. The instructions say...

Red wire: Connect to a fused and switched 12v positive source that is turned on and off with the ignition switch.

Black wire: Connect to good engine ground

Violet wire: Connect to oxygen sensor signal wire. Connect to vehicle wiring harness, not oxygen sensor since some oxygen sensors use shielded wire.

My main question is where could I bring the wires through the fire wall? And What wires in my car should I splise into? I need any help I can get guys!!!! I need to have this done by tomorrow night!

[This message has been edited by Monkie (edited October 13, 2001).]

 

You shouldn't need to run anything through the firewall, you should be able to access all the wires you need under the dash.