Signaling
Thread Starter
Supreme Member
Joined: Feb 2002
Posts: 1,036
Likes: 0
From: Prince Albert, Saskatchewan, Canada
Car: 1987 Trans Am GTA
Engine: 357ci Stealth Ram - Under Pressure
Transmission: Built 700r4/Pro Yank 3400 Extreme
Axle/Gears: 9-Bolt 3.27
Signaling
MY right signal light doesn't work. ( it does but...)
when I turn my signal light to go left, It flashed on the dash, and the light itself like it's supostu.
When I click it to turn right; The light on the dash stays -> (solid) and doesnt flash. The right signal light does come on, but it doesn't flash.
What gives?
when I turn my signal light to go left, It flashed on the dash, and the light itself like it's supostu.
When I click it to turn right; The light on the dash stays -> (solid) and doesnt flash. The right signal light does come on, but it doesn't flash.
What gives?
TGO Supporter
Joined: Sep 2000
Posts: 6,775
Likes: 27
From: So.west IN
Car: 87 Formula/ 00 Xtreme
Engine: TPI 305/ v6
Transmission: struggling t-5/ 4l60E
Axle/Gears: 3.08/ 3.23
Have you turned in on and looked front and back for a burned out bulb ? Usually the most common culprit for a signal that doesn't flash if the other side does. A bad ground could do the same as well though.
Thread Starter
Supreme Member
Joined: Feb 2002
Posts: 1,036
Likes: 0
From: Prince Albert, Saskatchewan, Canada
Car: 1987 Trans Am GTA
Engine: 357ci Stealth Ram - Under Pressure
Transmission: Built 700r4/Pro Yank 3400 Extreme
Axle/Gears: 9-Bolt 3.27
lights
the signal lights work, but they dont flash.
TGO Supporter
Joined: Sep 2000
Posts: 6,775
Likes: 27
From: So.west IN
Car: 87 Formula/ 00 Xtreme
Engine: TPI 305/ v6
Transmission: struggling t-5/ 4l60E
Axle/Gears: 3.08/ 3.23
If one side is working (flashing) inside and out and the other isn't. A bulb is out somewhere on the non-working side, there is a bad ground or your turn signal switch/cam is going south.
A single flasher relay is used for both left and right signals so, if it is working for one direction but not the other, the relay itself is good.
A good way to find burnt out signal bulbs is to turn the hazzards on and walk around the car.
A single flasher relay is used for both left and right signals so, if it is working for one direction but not the other, the relay itself is good.
A good way to find burnt out signal bulbs is to turn the hazzards on and walk around the car.
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
Oct 7, 2015 12:09 PM




