wiring problems
Thread Starter
Junior Member
Joined: Oct 2004
Posts: 20
Likes: 0
From: FLA
Car: 1988 Z28
Engine: 357 ci 472 hp at RWs
Transmission: 700r4
wiring problems
I have an 88 Z28 and I pulled out all the electronic gauges and went with all mechanical autometer gauges. I still have the wiring harness that plugged in to the circuit board. I am wanting to wire my gauges to have lights and to have turn signal indicators can any one help with this.... PS Trickster give me a Hand with this will YA.
Member
iTrader: (1)
Joined: Aug 2002
Posts: 239
Likes: 0
From: Suffolk VA, Cleveland NY
Car: 84 Berlinetta
Engine: junk 350
Transmission: TH350
Axle/Gears: Moser 4.56
Since I just did this, I can help ya.
Right blinker-- C1 Pin 12 -- Dark Blue
Left blinker-- C2 Pin 8 -- Light Blue
Hi Beam -- C2 Pin 10 -- Light Green
Dash Lights -- C2 Pin 11, or 12. -- Grey.
C2 is the Grey one on the left, C1 is the brown on the right.
On my cardomain site, page 9 shows my dash project. I think it probably looks like yours.
Right blinker-- C1 Pin 12 -- Dark Blue
Left blinker-- C2 Pin 8 -- Light Blue
Hi Beam -- C2 Pin 10 -- Light Green
Dash Lights -- C2 Pin 11, or 12. -- Grey.
C2 is the Grey one on the left, C1 is the brown on the right.
On my cardomain site, page 9 shows my dash project. I think it probably looks like yours.
Last edited by Eats5.0's; Jan 2, 2005 at 10:19 AM.
TGO Supporter
Joined: Sep 2003
Posts: 6,127
Likes: 11
From: conway, s.c.
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
Hello FLTraumaRN,
Check your E-mail. The contents were too big to post here.
P.S. : Eats5.0 is correct on the info he has given you for the lights.
Check your E-mail. The contents were too big to post here.
P.S. : Eats5.0 is correct on the info he has given you for the lights.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
Aug 11, 2015 10:11 PM
