HELP...no power ANYWHERE!!!
Thread Starter
Senior Member
Joined: Sep 2007
Posts: 678
Likes: 0
From: NORTH EAST GA
Car: 84 z28
Engine: 355
Transmission: TH350
Axle/Gears: one wheel peel
HELP...no power ANYWHERE!!!
ok, so my camaro hadnt been messed with for a couple months after the megashitter cable broke.......i decided to crank it just to see if it still ran....you know, well it started right up and ran for a little while......i reved it and the tack went crazy and the engine shut off, i thought the ground wire was loose, so i tightened becuase it was a little loose..........now when i went to put the cable back on it arcs like im hookin it up backwards (i know its not on backwards) and if you do put it on without getting electricuted i have no dash lights and no power to the starter or coil...........btw the car is carbed with a hei dist and no computer control
it acts like a hot wire is grounding out, but ive checked and cant find anything
that ive messed with thats bare.......it doesnt smoke with the cables on, but the ground wire does get hot........is there some kind of relay that coulda went bad when the ground wire came loose?
all help on this matter is appreciated
it acts like a hot wire is grounding out, but ive checked and cant find anything
that ive messed with thats bare.......it doesnt smoke with the cables on, but the ground wire does get hot........is there some kind of relay that coulda went bad when the ground wire came loose?
all help on this matter is appreciated
Re: HELP...no power ANYWHERE!!!
check your wiring oround the started or your distribution block. i would use an ohm meter from your positive wire to ground to find exact where the problem is ,but definetly use the meter it will save a lot of headache
Thread Starter
Senior Member
Joined: Sep 2007
Posts: 678
Likes: 0
From: NORTH EAST GA
Car: 84 z28
Engine: 355
Transmission: TH350
Axle/Gears: one wheel peel
Re: HELP...no power ANYWHERE!!!
i went out when it got dark to look for some arcing when i put the cables back on the battery.......it arced around the starter.....the main power wire had a small fray spot.....
Thread Starter
Senior Member
Joined: Sep 2007
Posts: 678
Likes: 0
From: NORTH EAST GA
Car: 84 z28
Engine: 355
Transmission: TH350
Axle/Gears: one wheel peel
Re: HELP...no power ANYWHERE!!!
thats a start and a finish.........fixed that and it didnt give anymore trouble
Thread
Thread Starter
Forum
Replies
Last Post




