My hi beams I believe (the 2 inner lights) do not go on. I even bought a new headlight today and put it in. I pull the light switch all the way, then pull the turn signal lever, and nothing. I tried every possible way and they do not go on.

 

The inner lights are the hi-only beams. The outter pair is switchable between low beams and high beams.
Your lo/hi beam switch might be out of adjustment, judging from your description. Try this tech article: http://www.austinthirdgen.org/index.php?pid=16

Sometimes it helps to tilt the steering wheel all the way up or down when switching the beams.

Hope this helps.
Lou

 

Thanks. I will try doing this and will ask any questions if i need to.

 

Odd. On that page you showed me, the switch it blue/white, but mine is all white?

 

I had a similar issue with mine and it was as simple as checking the ground wires on mine

 

Ground wires for the lights? Where?

 

mine were grounded right out of the harness behind the plug

 

Hmm plug. Do you mean one of these?

And how do I fix that problem?

 

on the plug at the headlamp its self...i dont believe that it is a switch issue. There should a ground wire that comes out of the harness and goes to the core support

 

Before I go crazy tracing it, where exactly does the harness begin under the hood?

 

start at the headlamp and work backwards....it should be only an inch or so away from them....

 

I forgot to mention...when i try to put the lo beams on, my highs shut off.