how to wire in stock gauges 91 Formula

Reply Subscribe

Thread Tools

Search this Thread

May 15, 2010 | 12:30 AM

mackjar66

Thread Starter

Member

iTrader: (9)

Joined: Aug 2009

Posts: 314

Likes: 0

From: Lafayette, IN

Car: 1989 GTA

Engine: pending install 383 tpi

Transmission: 700r4

Axle/Gears: 3.27

how to wire in stock gauges 91 Formula

ok i have a stock gauge set in the car id like to use went carb looking for wiring solutions for the following I HAVE NO TPI Wiring that came with the car I have to start from scratch

speedo with T-5
gas level
oil pressure
temp gauge
dual fans
RPM gauges
volt gauge

thanks

May 16, 2010 | 03:59 PM

$//<86TA>\\'s Avatar$

//<86TA>\\

Supreme Member

iTrader: (15)

Joined: Aug 2006

Posts: 12,812

Likes: 109

From: Central NJ

Car: 86 Trans Am

Engine: 408 stroker sbc

Transmission: TKO600

Axle/Gears: Moser full floater m9, 3:70 trutrac

Re: how to wire in stock gauges 91 Formula

so you have no dash harness?

May 16, 2010 | 07:12 PM

mackjar66

Thread Starter

Member

iTrader: (9)

Joined: Aug 2009

Posts: 314

Likes: 0

From: Lafayette, IN

Car: 1989 GTA

Engine: pending install 383 tpi

Transmission: 700r4

Axle/Gears: 3.27

Re: how to wire in stock gauges 91 Formula

no i have the dash harness all intact just not sure where to start or even if i can still use the stock gauges

May 16, 2010 | 07:21 PM

$//<86TA>\\'s Avatar$

//<86TA>\\

Supreme Member

iTrader: (15)

Joined: Aug 2006

Posts: 12,812

Likes: 109

From: Central NJ

Car: 86 Trans Am

Engine: 408 stroker sbc

Transmission: TKO600

Axle/Gears: Moser full floater m9, 3:70 trutrac

Re: how to wire in stock gauges 91 Formula

the gauges will work without the computer, the fans may not.

speedo may not work, i know ecm gets the speed signal, but in not sure if the gauge will be affected