Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

89 Iroc 350 auto won't start

Thread Tools
 
Search this Thread
 
Old Aug 9, 2014 | 07:19 PM
  #1  
Napalm's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2014
Posts: 9
Likes: 0
From: Tomball, TX
Engine: 350
89 Iroc 350 auto won't start

To start off in the sequence of events. This car is not driven very much. I started it and pulled it out of the garage and let it run for about 10-15 minutes. I then proceeded to pull it back into the garage and turned it off. The next week i went to do the same thing and the car turned over but would not start. As i am on the ignition next thing you know i see smoke coming from under the hood. I pop the hood and get out to check and find that a ground from the battery to the apron is melted. I replaced the ground thinking that maybe there was a loose connection. I tried to start again and the same thing happened so i eliminated the ground. Next thing you know i still have a no start and i start checking things. I found that i have no spark. I proceeded to replace the coil and the ignition control module. Now i have a week spark but still a no start. What should i do or check at this point. I have checked the other grounds and they seem okay.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Frozer!!!
Camaros for Sale
35
Jan 19, 2024 04:55 PM
Brcharrelson
TPI
15
Aug 26, 2015 07:47 PM
justin57
TBI
30
Aug 20, 2015 07:05 PM
wruiz
TPI
15
Aug 13, 2015 09:07 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM




All times are GMT -5. The time now is 01:23 PM.