90 92 infl rest sensor position
#1
Junior Member
Thread Starter
Join Date: May 2019
Location: berlin
Posts: 25
Likes: 0
Received 2 Likes
on
2 Posts
Car: camaro 91 z28
Engine: 305
Transmission: AT
90 92 infl rest sensor position
Hello.
In my 91 z28 the pre owner removed the airbag front sensor and cutted the wires.
Now I got a used sensor and the whole headlight harness.
But I don't know where to put the sensor. I can't see any wholes where to bolt it.
Does someone have a picture or can make one of the location?
In my 91 z28 the pre owner removed the airbag front sensor and cutted the wires.
Now I got a used sensor and the whole headlight harness.
But I don't know where to put the sensor. I can't see any wholes where to bolt it.
Does someone have a picture or can make one of the location?
#3
Junior Member
Thread Starter
Join Date: May 2019
Location: berlin
Posts: 25
Likes: 0
Received 2 Likes
on
2 Posts
Car: camaro 91 z28
Engine: 305
Transmission: AT
Re: 90 92 infl rest sensor position
Ok I have searched everything in the internet and now I know where it should be.
Seems like someone in the past changed the radiator support because the upper support on mine doesnt have the bracket where the sensor is screwed.
Now everything makes sense why they cutted the sensor changed the steering wheel and pulled out the infl rest bulb in the gauge.
There had to be an accident in the past..
Seems like someone in the past changed the radiator support because the upper support on mine doesnt have the bracket where the sensor is screwed.
Now everything makes sense why they cutted the sensor changed the steering wheel and pulled out the infl rest bulb in the gauge.
There had to be an accident in the past..
#4
Supreme Member
Join Date: Jun 2015
Location: Austin, TX
Posts: 1,907
Received 176 Likes
on
135 Posts
Car: 90 Formula / T-tops
Engine: 305 TPI
Transmission: MD8
Re: 90 92 infl rest sensor position
The service manual goes to great detail on how to mount this sensor. they seemed pretty sensitive about it. there are 2 small screws up front, and two 10mm bolts in back that secure the bracket. not quite sure why the back wasn't welded rather than bolted. The front part of the bracket is welded.
Thread
Thread Starter
Forum
Replies
Last Post