wiring harness for dash and interior
Thread Starter
Senior Member
Joined: Sep 2004
Posts: 952
Likes: 6
From: PITTSBURGH, PA
Car: 85 IROC-Z Z-28, BLUE & SILVER
Engine: 5.7L & 5.0L
Transmission: 700R4
Axle/Gears: FACTORY
wiring harness for dash and interior
does anyone make a new wiring harness that replaces the one under the dash and inside the car? painless has them for the tpi motor only.
any suggestions on how to get new wiring for the dash stuff, gauge cluster, switches, etc
thanks
any suggestions on how to get new wiring for the dash stuff, gauge cluster, switches, etc
thanks
Supreme Member
Joined: Jul 2006
Posts: 2,863
Likes: 788
From: 212 is up in this Bit@#
Car: Resto-Mod 1987 IROC-Z Clone
Engine: Alky fed L92 Vortec Twin-Turbo 6.8L
Transmission: My own built/ design 4L80M
Axle/Gears: Custom 12 bolt (4.10:1)
Re: wiring harness for dash and interior
There are a few guys here that sell used Harnesses for the Passenger-Compartment, including the Dash-Board Harness.
I do not believe anyone builds new ones... many of the Electrical-Connectors have been too difficult to find new.
I do not believe anyone builds new ones... many of the Electrical-Connectors have been too difficult to find new.
Joined: Feb 2001
Posts: 13,753
Likes: 560
From: Cincinnati, OH
Car: '90 RS
Engine: 377 LSX
Transmission: Magnum T56
Re: wiring harness for dash and interior
If you need a replacement harness just find a god used one If you are goin to go custom, pull it out and pin it the way you need. It takes time but you will learn a lot about your car when tracing through the body harness circuits.
Joined: Sep 1999
Posts: 4,353
Likes: 308
From: NJ
Car: 92 Firebird
Engine: 4.8 LR4
Transmission: T56
Axle/Gears: 3.45 9 Bolt
Re: wiring harness for dash and interior
You will have to get a used one from the same year and model car, or you might be making changes to get everything to work afterwards
Thread
Thread Starter
Forum
Replies
Last Post
Drone358
Electronics
0
Jun 16, 2015 09:25 PM