More stuff on the chopping block,
Scoggin Dickey manifold, stock runners and plenum (All powder coated metallic silver), AFPR, BBK 52mm throttle body, all (almost, 98%) stainless hardware, billet EGR block off plates, brand new Bosch 24lb/hr injectors, and new IAC, TPS, CTS and IAT from TPIparts.net.

The set up just needs to be dusted off and installed.

$800 plus shipping or feel free to pick up in Charleston SC.

I'm not splitting it up and I'm not interested in trades unless it's towards a 2005 or newer 450 size race quad.

mccaskib@comcast.net

 

Throw me some offers. Worst that can happen is I'll say no.

 

btt

 

is this setup for a 90-92 tpi

 

Nope, it is a MAF system off of a 1987 GTA.

Btw, the MAF sensor is included.

 

Still here

 

btt

 

btt

 

what would i have to modify to throw this on my 89 305 TPI.

 

swap out your fuel rails and driver side runner. I would also use your original injectors because 24 lbs is too much for a stock 305.

 

btt still here

$700 + shipping

 

btt

 

How much shipped to 96701?

 

I will need to get it boxed up tomorrow and get an exact weight and dimension. The quote from www.ups.com based on my estimate was pretty scary. I'll check USPS after I get it boxed.

 

Very tempting.....It would drop right on my 87, once I put on Vortec heads.

 

Ironically, I have a set of Fastburn aluminum heads for sale as well and I give great bulk discounts.

 

I can only imagine the cost + shipping (especially shipping!) on heads, beside the intake parts.

 

it would be around $75 to ship all of it from sc to tx or vice versa it's all aluminum so it isn't that bad.

 

Separately, I'm asking $1550 + shipping for both (heads and TPI). If someone wants both, I'll go $1525 shipped via my choice of shipper (most likely USPS).

 

Looks like about $60 via USPS Parcel Post.

 

btt

 

btt

 

btt

$700 shipped in Lower 48

 

Stock Vortecs or higher lift capable, screw in studs, etc.?

 

The heads are GMPP Fastburns. Screw in studs. I don't know the exact lift they are capable of, but the HotCam is .525, so it will at least handle that.

The $700 price is for the intake setup only though.

 

Hey worker, I sent you a PM about this intake setup

 

replied

A few extra pics

 

Sold to Jer82Z28