[OH] Mild Cam and Lifters
Thread Starter
Junior Member
iTrader: (3)
Joined: Nov 2008
Posts: 93
Likes: 1
From: Lima, Ohio and Ft. Lauderdale, FL
Car: 1983 Camaro Z28
Engine: 350
Transmission: 700R4
Axle/Gears: 3.42
Mild Cam and Lifters
Stage 1 HP SBC 350 camshaft .050 Duration 204/214 Cam Lift .280/.295 Valve Lift Int .420 / Exh .443 Lobe Center 107/117
This cam came in my Engine Tech rebuild kit. Gave gave my 350 a nice idle and a really smooth, consistent power band. Would be great for any mild 305 or 350. Used for less than 5,000 miles.
$50 plus shipping OBO
This cam came in my Engine Tech rebuild kit. Gave gave my 350 a nice idle and a really smooth, consistent power band. Would be great for any mild 305 or 350. Used for less than 5,000 miles.
$50 plus shipping OBO
Trending Topics
Member
iTrader: (10)
Joined: Jul 2008
Posts: 426
Likes: 2
From: Binghamton, NY
Car: 1986 IROC-Z
Engine: 360cu @ 10.5:1
Transmission: T56 - Pro 5.0
Axle/Gears: 4.10 - Zexel Torsen - Moser Axles
Re: Mild Cam and Lifters
I can vouch for the grind on this cam - I had an ELGIN cam with the same specs. Awesome down low torque and consistent powerband. The only downfall is that it starts to run out of steam a little beyond 5,000 rpms. I made the switch to a more rev happy cam (XE274) since I have 4.10's.
If you're aim is to find an awesome torque stick, however, this is the one you want.
If you're aim is to find an awesome torque stick, however, this is the one you want.
Last edited by plasmeh; Jun 14, 2010 at 03:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
dimented24x7
Tech / General Engine
4
Sep 6, 2015 03:51 PM
