I have an entire TPI intake off of an 85' iroc.
Everything is fresh, clean, shiny, and ready to go.
Even comes with all new shiny bolts.
Rail and injectors included.
I go have the MAF, and the ECM just no pictures right now.
The intake manifold was rigged to fit onto a post 87' block as you can see in the pictures.

Harness is super-complete, every single thing is perfect except for a cut b+ connection, and a broken ground ring. All connectors are intact.

This would be perfect to convert any carb'd car into a TPI.
ECM -20
MAF -30
Runners -15
Plenum -25
Harness - 80
Lower intake -45
throttle body -20
fuel rail -15
all 9 injectors -15
duct between maf and tb -10
EGR -5
distributer - 20

 

 

 

TTT
Taking any offers.

 

if you part out i need the harness !

 

Still have it, what's the lowest you'd take. I can pick up.

 

PM's Sent

 

Super early morning bump.
$300 shipped

 

Still have? Will do 300 if you still can

 

yeah, still got it.

 

What would I need to put this onto my car and run it

 

some zip ties, a socket wrench, 3 nuts, 2 bolts, 2 screw clamps, and about 3 inches of electrical tape.

but seriously, nothing. everything is there to run

 

still for sale, ttt

 

Harness may be gone today.
Still taking offers on everything, but it will probably be parted out.

Still have:
ECM -20
MAF -30
Runners -15
Plenum -25
Lower intake -45
throttle body -20
fuel rail -15
all 9 injectors -15
duct between maf and tb -10
EGR -5
distributer - 20

 

8===>

 

hey what emc do you got is it for a 305 OD tranny ? if so i want that the maf and the duct between maf and tb ,the runners and all the bolts from the manafold to the tpi you want to give me a deal and throw it in with my harness and i'll send you some more money ?

 

Yeah its a 305 with the 700r4
PM is sent.

 

up

 

Is the MAF still available, and if so how much for it shipped to zip 17063?

 

duct still available? good condition?

 

I'll take the plenum. Do you, by chance, have the extension (distributor cover) to go with it?
Jeff Skogsbergh (jesredvette)
South Pasadena, California 91030
jescfp@gte.net

 

Plenum still available? Left a couple of PM's.

 

what parts do you have im ready to buy if you have any parts available

 

do u have a all the air intake and tpi mass air flow sensor how much and shipped to 96002