[VA] JET Stage 2 Chip
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
JET Stage 2 Chip
I'm selling my JET Stage 2 chip that is for an 85 TPI with auto trans. Put the stock chip back in so I can go back to regular gas.
$100 SHIPPED.
$100 SHIPPED.
Joined: Dec 2004
Posts: 16,889
Likes: 1,013
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: JET Stage 2 Chip
if its listed for a 85 it would be for the 870 ecm and would be a eprom in a robinson nugget holder and will not work in the 86-89 1227165 maf ecm .
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
Re: JET Stage 2 Chip
Incorrect. The 86 and up style eproms were nothing more than an 85 style calpak and prom housed in a single plastic shell. if you are careful, you can swap out the prom and calpak individually.
HOWEVER, I believe 85 and 87 might have had a slightly different Cam profile. I'll check the tech articles once I get home.
Trending Topics
Joined: Dec 2004
Posts: 16,889
Likes: 1,013
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: JET Stage 2 Chip
Incorrect. The 86 and up style eproms were nothing more than an 85 style calpak and prom housed in a single plastic shell. if you are careful, you can swap out the prom and calpak individually.
HOWEVER, I believe 85 and 87 might have had a slightly different Cam profile. I'll check the tech articles once I get home.
HOWEVER, I believe 85 and 87 might have had a slightly different Cam profile. I'll check the tech articles once I get home.
Last edited by Tuned Performance; Dec 28, 2011 at 07:01 PM. Reason: Im confused !!!
Thread
Thread Starter
Forum
Replies
Last Post