I have a Accel High flow lower intake for sale 300$ shipped I also am selling a nice ZZ4 used take out cam out oh my 5k ZZ4 I dont have pics at the moment but its clean no wear and almost ready to install for 125$ shipped paypal accepted and I am not on this board very often so please email me at rwhoag1969@verizon.net my Ebay name is zman1969 also and have good long term feedback







intake and cam are sold

 

emailed you on both.

 

I have also added I have an OEM GM wonderbar f/s 30$ shipped and a take out low mile torsen I had bought a couple years ago and never used this looks nice! 175$ shipped I can get pics if needed on both these items

 

interested in the torsen unit. Got anything else? ring/pinion/etc?

 

I dont but a buddy pulls gears frequently he has some GM 4.30's at the moment- ususally gets 65$ a set. these are factory GM take outs not A/M and they have lived behind a 6 cyl so they are nice and no issues. I always prefer good used GM gears over aftermarkets

 

dang, 4.3s? a little steep for my DD... think he might have any 3.08-3.23? 3.45 is alright too but not preferred.

 

no sorry he usually gets 3.73's 4.10's 4.11's and 4.30s he has also found 4.56's all factory GM gears! the higher gears are common(like you want) and dont sell well S10 blazers are plentiful in pick and pull yards - I dont remember the codes -I know 3.73 are GT4 you will need 3.23 and lower for a 3 series carrier like what I have for sale. IIRC 3.08 and higher gears are 2 series
3.42's are common

 

is the intake still available?

 

Do you happen to remember what size plug you put in the intake for the cold start delete?

 

The drivers side csi air passage does not get blocked off in the manifold. 85-88 tpi runners have the csi hols in the . IIRC you can use a 3/4 expansion plug or http://www.ebay.com/itm/Chevy-TPI-SBC-Cold-Start-9th-Injector-Block-Off-Delete-Kit-/380661635968?pt=Motors_Car_Truck_Parts_Accessories&hash=item58a1339b80&vxp=mtr

 

I was referring to the hole where the sensor goes, I can't remember the name but I think it has something to do with the cold start. Goes right next to the coolant temp sender

 

oh sorry The cold start Timer switch is a 3/8 Npt plug

 

GUYS, please ask your questions and answers in the right forum - this is a for sale thread not Q+A
thanks

 

yes intake is available - all parts listed are

 

bumping up all parts still available may have to list on EPay if no luck here

 

is the torsen still available, interested in any trades?

 

Torsen and wonder bar are still available - what ya got to trade?
Accel Intake and ZZ4 camshaft are sold

 

something's goofy here, the inlet and outlets are smaller on this accel. Im thinking it was cast as a tpis bigmouth and labeled incorrectly nd un ported. the accel in the picture has not been ported.

 

sry i didn't reply, i had to go to fort chaffee Arkansas for my annual training for the army reserve, if you still have the torsen i am still interested, i have some cash now, the only stuff i have to trade is old 85 z28 parts, such as fenders, t tops, doors, turbo700r4, red 15" z28 wheels with tires, tuned port injection, and a couple other parts.

let me know

 

Still have the torsen?