Have a used and in good condition spohn transmission cross member for a 700r4 auto trans. Has a drive shaft hoop and is meant for a spohn torque arm. I switched to a t-56 setup and had to get a different cross member. Looking to get $75 plus the ride.

 

This is a torque arm relocation set-up, correct? Hoping it'll work with a stock torque arm.

 

Is this still available?

 

Yes it is still available.

 

Can you give me a shipping quote to 55709? Thanks

 

Thanks for the inquiry. Would cost around $50 depending on how fast you need it.

 

Thanks, I’m interested and will most likely buy it from you. I just need to figure out if this will work with a tko 600. I’ve been told using a Lakewood shatterproof bell keeping the trans straight up and down not canted, using a gym tko bolting straight up to the engine with no adapter plate you don’t need to change drive shaft length. So theatrically it should work right?

 

Irocjason can you pm me your PayPal address? And total. I’ll go with the cheeper shipping method. I’ll pm you my address.

 

2 year old thread, any chance it's still available since there was no update on it selling?