Im looking for a stcok TC or a small stall, and i nalso need a FlexPlate for a 350.
Im hitting abit of a down time in money (army artical 15) so the cheeper the better i just need to get it off blocks and rolling again.

 

i got a used flexplate and converter out of an 94 t/a lt1.. should all fit. what year is your 350 and what size flexplate do you have. i think i still have a big 1 piece rms and a big 2 piece rms also. email me at pr0zac623@aol.com

 

i have a 153 tooth flexplate for a 2 piece rms i'd sell for $10 plus shipping. not sure if that'll help you or not.

 

I have a 153 tooth im not sure if its one or two pice main seal. how do i find that out
engine is a 86-95 350 is all i can tellyou its a reman. so the numbers onteh block have been milled off, i didnt knwo that till after i put it in. what other info do you need

 

if the crank has a locating pin on the back where the flexplate would bolt to, then it's a one piece rear main seal. the flexplate would not physically bolt to it. Also a one piece rear main seal flexplate would have a balance weight on one of the sides of the flexplate whereas the 2 piece RMS wouldn't.

 

I have a stock 700-R4 converter if your interested pm me.

 

ok men I have already got a sweet deal on the Flex Plate, i listed i was lookng for stock but if someone has a stall that will fit my application (non stock) let me know info listed below

Im looking to eventually make this a 383 stroker

 

Hey just to let you all know that i have gotten at TC, so im outta the market for both things. thanks again for all your help guys