Need T-56 Bellhousing of an LT-1

Reply Subscribe

Thread Tools

Search this Thread

May 17, 2007 | 07:42 AM

NGIGE

Thread Starter

Junior Member

Joined: Jun 2006

Posts: 34

Likes: 0

From: Austin TX

Car: 88 Turbo TA

Engine: 355 to be replaced by a 406

Transmission: Viper Spec T56

Axle/Gears: Stock Until they go BOOM

Need T-56 Bellhousing of an LT-1

Like it says i need a bellhousing out of a 93-97 LT-1 Camaro or Bird. i am located in Austin TX. thanks.

May 26, 2007 | 11:56 PM

trackbird

Member

iTrader: (7)

Joined: Jun 2005

Posts: 107

Likes: 1

From: Columbus, OH

Car: 1991 Corvette

Engine: 353 cu in

Transmission: M6

Axle/Gears: 3.45

Re: Need T-56 Bellhousing of an LT-1

I have one in the garage that I bought for a project and then I bought a car with a T56 already installed.

Let me know if you still need one.

Thanks,

Kevin

trackbird(at)columbus.rr.com

May 29, 2007 | 06:36 AM

NGIGE

Thread Starter

Junior Member

Joined: Jun 2006

Posts: 34

Likes: 0

From: Austin TX

Car: 88 Turbo TA

Engine: 355 to be replaced by a 406

Transmission: Viper Spec T56

Axle/Gears: Stock Until they go BOOM

Re: Need T-56 Bellhousing of an LT-1

how much you looking to get?

Thanks,

Francis.

Last edited by NGIGE; May 29, 2007 at 07:47 AM.

May 29, 2007 | 10:28 AM

trackbird

Member

iTrader: (7)

Joined: Jun 2005

Posts: 107

Likes: 1

From: Columbus, OH

Car: 1991 Corvette

Engine: 353 cu in

Transmission: M6

Axle/Gears: 3.45

Re: Need T-56 Bellhousing of an LT-1

I was looking for $95 shipped in the 48 states of the US.

I've got a flywheel too, if you need one (it's an LT1 that was an SLP "takeout" and has about 2 miles on it, it will fit a 1 piece rear main seal small block).