I need a strong running 350 prefer pre 86
needs to be at least equiv to goodwrench 290hp crate. medium miles are ok...
I looking to pay 700-800 bucks. The more local the better... I'm in Central NY
please email allstellar@yahoo.com


Thanks
timg

 

bum bum bump

 

sent you an email.

 

email back to you and bump...

 

I have an 86 and up 355ci rebuilt, Has about 10mi on rebuild. Its all stock, 2blt mains Fuel injected block. 194casting heads, Also rebuilt. Everything has been rebuilt top to bottom. Has water pump on it and harmonic balancer. Has a carbed intake on it for now but its not meant for it. I live in pa my parents have a house by binghampton Ny im about 15 or 20 mi from the boarder. I can meet too that point or farther.

 

email sent....

 

I couldnt reply to you, but the intake is off of a 87 monte carlo SS It carbbed but the motor is suppose to be run on TPI or TBI. Id like 900 for it, Only the cam has been broken in. Motor has atleast or alittle more then 10miles on rebuild.

 

I made my email work.... can you send me your phone number?
thanks
timg

 

i might b willing to get rid of one of my 4 bolt main 350's in a bit

 

I'm up in Champlain, New York and have a 1979 Corvette that I'm parting...the engine was done at local machine shop, Crane cam, 305 (58cc heads), flat tops etc. Has less that 5000 miles...maybe even less than 2000 on complete rebuild. You could hear it run before I remove it. Was going to put it in my 33 Chevy and lay on a TPI setup (I have several TPI's) but recently picked up a 454. The heads are center bolt with a stock quadrajet (police package) intake manifold OEM for center bolt heads. The police cars 88-90 were still sent out with carbs...not TBI.

The engine pictures may not look the best...but it's been sitting in my barn for a couple of years. You can have the whole vette for 3K or just the engine.

http://www.putfile.com/33chevy/images/62901

Check out the sight and send me an e-mail from the e-mail address noted.

Ed

 

i have a sbc 400 short block, with forged speedpro flat top pistons with less than 10k on it and ill take $500

 

i got the gm 350 290HP brand new i was putting it into my camaro but got a truck instead have the motor sitten 1800.00 still in plastic